Chevrolet Spark Owners Manual: Engine Oil Pressure Light
Caution
Lack of proper engine oil maintenance can damage the engine. Driving with the engine oil low can also damage the engine. The repairs would not be covered by the vehicle warranty.
Check the oil level as soon as possible. Add oil if required, but if the oil level is within the operating range and the oil pressure is still low, have the vehicle serviced.
Always follow the maintenance schedule for changing engine oil.
This light should come on briefly
as the engine is started. If it does not come on, have the vehicle serviced by your
dealer.
If the light comes on and stays on, it means that oil is not flowing through the engine properly. The vehicle could be low on oil and might have some other system problem. See your dealer.
Tire Pressure Light
For vehicles with the Tire Pressure
Monitor System (TPMS), this light comes on briefly when the engine is started. It
provides information about tire pressures and the TPMS.
When the Light Is On ...
Low Fuel Warning Light
The low fuel warning light comes
on briefly when the vehicle is started.
This light also comes on when the fuel level is low. When fuel is added, the
light should go off. If it does not, have the ...
Other materials:
Recreational Vehicle Towing
Recreational vehicle towing refers to towing the vehicle behind another vehicle,
such as behind a motor home. The two most common types of recreational vehicle towing
are known as dinghy towing and dolly towing. Dinghy towing is towing the vehicle
with all four wheels on the ground. Dolly towi ...
Different Size Tires and Wheels
If wheels or tires are installed that are a different size than the original
equipment wheels and tires, vehicle performance, including its braking, ride and
handling characteristics, stability, and resistance to rollover may be affected.
If the vehicle has electronic systems such as antilock ...
High/Low-Beam Headlamp
Connector Retaining Tab
Connector Release
Headlamp Bulb
To replace a headlamp bulb:
Open the hood. See Hood on page 10-5.
Remove the connector retaining tab (1).
Disconnect the wiring harness connector from the bulb (3) by pressing the
connector release (2) and pulling strai ...
