Chevrolet Spark Owners Manual: Tire Pressure Light
For vehicles with the Tire Pressure
Monitor System (TPMS), this light comes on briefly when the engine is started. It
provides information about tire pressures and the TPMS.
When the Light Is On Steady
This indicates that one or more of the tires are significantly underinflated.
Stop as soon as possible, and inflate the tires to the pressure value shown on the Tire and Loading Information label. See Tire Pressure on page 10-43.
When the Light Flashes First and Then Is On Steady
If the light flashes for about a minute and then stays on, there may be a problem with the TPMS. If the problem is not corrected, the light will come on at every ignition cycle.
See Tire Pressure Monitor Operation on page 10-45.
Engine Coolant Temperature Warning Light
This light comes on briefly while
starting the vehicle.
If it does not, have the vehicle serviced by your dealer. If the system is working
normally the indicator light goes off.
Caution
The eng ...
Engine Oil Pressure Light
Caution
Lack of proper engine oil maintenance can damage the engine. Driving
with the engine oil low can also damage the engine. The repairs would not be covered
by the vehicle warranty.
Check t ...
Other materials:
Lap-Shoulder Belt
All seating positions in the vehicle have a lap-shoulder belt.
The following instructions explain how to wear a lap-shoulder belt properly.
Adjust the seat, if the seat is adjustable, so you can sit up straight.
To see how, see “Seats” in the Index.
Pick up the latch plate and pull ...
Tire Sealant and Compressor Kit
Warning
Idling a vehicle in an enclosed area with poor ventilation is
dangerous. Engine exhaust may enter the vehicle. Engine exhaust contains carbon
monoxide (CO) which cannot be seen or smelled.
It can cause unconsciousness and even death. Never run the engine in an enclosed
area that has ...
High/Low-Beam Headlamp
Connector Retaining Tab
Connector Release
Headlamp Bulb
To replace a headlamp bulb:
Open the hood. See Hood on page 10-5.
Remove the connector retaining tab (1).
Disconnect the wiring harness connector from the bulb (3) by pressing the
connector release (2) and pulling strai ...
