Chevrolet Spark Owners Manual: Battery
The original equipment battery is maintenance free. Do not remove the cap and do not add fluid.
Refer to the replacement number shown on the original battery label when a new battery is needed. See Engine Compartment Overview on page 10-7 for battery location.
Warning
WARNING: Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. See California Proposition 65 Warning on page 10-3.
Vehicle Storage
Warning
Batteries have acid that can burn you and gas that can explode.
You can be badly hurt if you are not careful. See Jump Starting on page 10-64 for tips on working around a battery without getting hurt.
Infrequent Usage: Remove the black, negative (-) cable from the battery to keep the battery from running down.
Extended Storage: Remove the black, negative (-) cable from the battery or use a battery trickle charger.
Brake Fluid
The brake/clutch master cylinder
reservoir is filled with DOT 4 brake fluid as indicated on the reservoir cap. See
Engine Compartment Overview on page 10-7 for the location of the reservoir.
The ...
Starter Switch Check
Warning
When you are doing this inspection, the vehicle could move suddenly.
If the vehicle moves, you or others could be injured.
Before starting this check, be sure there is enough room aroun ...
Other materials:
Ignition Positions
The ignition switch has four different positions.
The uplevel key must be fully extended to start the vehicle.
To shift out of P (Park), the ignition must be in ON/RUN and the regular brake
pedal applied.
1 (STOPPING THE ENGINE/LOCK/ OFF): When the vehicle is stopped, turn the ignition
sw ...
Automatic Door Locks
If equipped, the vehicle is programmed so that when the doors are closed, the
ignition is on, and the shift lever is moved out of P (Park) for automatic transmissions,
or the vehicle speed is above 13 km/h (8 mph) for manual transmissions, the doors
and the liftgate will lock.
To unlock the d ...
License Plate Lamp
Attachment Screws
License Plate Bulb
Bulb Socket
To replace a license plate lamp bulb:
Remove the two screws (1) from the license plate lamp assembly.
Turn and pull the license plate lamp assembly down.
Turn the bulb socket (3) counterclockwise and pull it out of the lamp assem ...
