Chevrolet Spark Owners Manual: Engine Coolant Temperature Warning Light
This light comes on briefly while
starting the vehicle.
If it does not, have the vehicle serviced by your dealer. If the system is working normally the indicator light goes off.
Caution
The engine coolant temperature warning light indicates that the vehicle has overheated. Driving with this light on can damage the engine and it may not be covered by the vehicle warranty. See Engine Overheating on page 10-17.
The engine coolant temperature warning light comes on when the engine has overheated.
If this happens, pull over and turn off the engine as soon as possible.
See Engine Overheating on page 10-17.
Traction Control System (TCS)/StabiliTrak Light
The StabiliTrak or Traction Control
System (TCS) indicator/warning light comes on briefly when the engine is started.
If the light does not come on, have the vehicle serviced by your dealer.
If t ...
Tire Pressure Light
For vehicles with the Tire Pressure
Monitor System (TPMS), this light comes on briefly when the engine is started. It
provides information about tire pressures and the TPMS.
When the Light Is On ...
Other materials:
Passenger Airbag Status Indicator
The vehicle has a passenger sensing system. See Passenger Sensing System on page
3-25 for important safety information. The center display has a passenger airbag
status indicator.
United States
Canada
When the vehicle is started, the passenger airbag status indicator will light
ON a ...
General Information
Your vehicle is an important investment. This section describes the required
maintenance for the vehicle. Follow this schedule to help protect against major
repair expenses resulting from neglect or inadequate maintenance. It may also help
to maintain the value of the vehicle if it is sold. It ...
High/Low-Beam Headlamp
Connector Retaining Tab
Connector Release
Headlamp Bulb
To replace a headlamp bulb:
Open the hood. See Hood on page 10-5.
Remove the connector retaining tab (1).
Disconnect the wiring harness connector from the bulb (3) by pressing the
connector release (2) and pulling strai ...
