Chevrolet Spark Owners Manual: Headlamp High/Low-Beam Changer
The headlamps must be on for this feature to work.
Push the turn signal lever away from you to turn the high beams on.
The 
light comes on in the instrument
cluster while the high beams are on and the ignition is turned to ON/RUN.
To return to low beams, push the lever again or pull the lever toward you and release.
Exterior Lamps Off Reminder
A reminder chime will sound when the headlamps or parking lamps are manually
turned on when the ignition is off and a door is open. To disable the chime, turn
the light off. ...
Flash-to-Pass
This feature is used to signal to the vehicle ahead that you want to pass.
Pull the turn signal lever toward you until the high-beam headlamps come on,
then release the lever to turn them off. ...
Other materials:
Charging System Light
This light will come on briefly
when the ignition is turned on, and the engine is not running, as a check to show
it is working.
It should go out when the engine is started. If it stays on, or comes on while
driving, there may be a problem with the electrical charging system. Have it checked ...
Using the Preset Buttons
Up to seven favorites pages can be saved, and each page can store up to five
channels.
To change a preset button, tune to the new desired channel and hold the button.
Listening to Preset Channels
Continue pressing or
to select the desired favorites
page.
Press the preset button ...
Lower Anchor and Top Tether Anchor Locations
(Top Tether Anchor): Seating positions
with top tether anchors.
(Lower Anchor): Seating positions
with two lower anchors.
To assist in locating the lower
anchors, each seating position with lower anchors has two labels, near the crease
between the seatback and the seat cushion.
To a ...
