Chevrolet Spark Owners Manual: Automatic Transmission Shift Lock Control Function Check
Warning
When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.
- Before starting this check, be sure there is enough room around the vehicle. It should be parked on a level surface.
- Apply the parking brake. Be ready to apply the regular brake immediately if the vehicle begins to move.
- With the engine off, turn the ignition on, but do not start the engine. Without applying the regular brake, try to move the shift lever out of P (Park) with normal effort. If the shift lever moves out of P (Park), contact your dealer for service.
Starter Switch Check
Warning
When you are doing this inspection, the vehicle could move suddenly.
If the vehicle moves, you or others could be injured.
Before starting this check, be sure there is enough room aroun ...
Ignition Transmission Lock Check
While parked and with the parking brake set, try to turn the ignition to LOCK/OFF
in each shift lever position.
The ignition should turn to LOCK/OFF only when the shift lever is in P (Park).
T ...
Other materials:
Engine Oil
To ensure proper engine performance and long life, careful attention must be
paid to engine oil.
Following these simple, but important steps will help protect your investment:
Always use engine oil approved to the proper specification and of the proper
viscosity grade. See “Selecting the R ...
Tire Pressure Monitor Operation
This vehicle may have a Tire Pressure Monitor System (TPMS).
The TPMS is designed to warn the driver when a low tire pressure condition exists.
TPMS sensors are mounted onto each tire and wheel assembly, excluding the spare
tire and wheel assembly. The TPMS sensors monitor the air pressure in t ...
Remote Keyless Entry (RKE) System
See Radio Frequency Statement on page 13-12.
If there is a decrease in the RKE operating range:
Check the distance. The transmitter may be too far from the vehicle.
Check the location. Other vehicles or objects may be blocking the signal.
Check the transmitter's battery.
See “Battery ...