For vehicles with high gloss surfaces or vehicle displays, use a microfiber cloth to wipe surfaces.
Before wiping the surface with the microfiber cloth, use a soft bristle brush to remove dirt that could scratch the surface. Then use the microfiber cloth by gently rubbing to clean. Never use window cleaners or solvents. Periodically hand wash the microfiber cloth separately, using mild soap. Do not use bleach or fabric softener. Rinse thoroughly and air dry before next use.
Caution
Do not attach a device with a suction cup to the display. This may cause damage and would not be covered by the vehicle warranty.
Fabric/Carpet/Suede
Instrument Panel, Leather, Vinyl, Other Plastic Surfaces, Low Gloss Paint Surfaces
and Natural Open Pore Wood SurfacesFront Turn Signal/Parking Lamps
To replace a front turn signal bulb:
Open the hood. See Hood on page 10-5.
Turn the bulb socket counterclockwise and pull it out of the lamp housing.
Pull the bulb straight out of the bulb socket.
Install the new bulb into the socket by pressing it in.
Install the socket into the ...
Retained Accessory Power (RAP)
These vehicle accessories may be used for up to 10 minutes after the engine is
turned off:
Audio System
Power Windows
The power windows will continue to work for up to 10 minutes or until any door
is opened. The radio will work when the key is in ON/RUN or ACC/ACCESSORY. Once
the key ...
High-Beam On Light
This light comes on when the high-beam
headlamps are in use.
See Headlamp High/Low-Beam Changer on page 6-1 for more information.
Daytime Running Lamps (DRL) Indicator Light
This light, in the display on the
top of the center stack, turns on whenever the Daytime Running Lamps are in use.
Se ...