Chevrolet Spark Owners Manual: If the On Indicator Is Lit for a Child Restraint
If a child restraint has been installed and the on indicator is lit:
- Turn the vehicle off.
- Remove the child restraint from the vehicle.
- Remove any additional items from the seat such as blankets, cushions, seat covers, seat heaters, or seat massagers.
- Reinstall the child restraint following the directions provided by the child restraint manufacturer and refer to Securing Child Restraints (Rear Seat) on page 3-47 or Securing Child Restraints (Front Passenger Seat) on page 3-49.
- If, after reinstalling the child restraint and restarting the vehicle, the on indicator is still lit, turn the vehicle off. Then slightly recline the vehicle seatback and adjust the seat cushion, if adjustable, to make sure that the vehicle seatback is not pushing the child restraint into the seat cushion. Also make sure the child restraint is not trapped under the vehicle head restraint. If this happens, adjust the head restraint. See Head Restraints on page 3-2.
- Restart the vehicle.
If the on indicator is still lit, secure the child in the child restraint in a rear seat position in the vehicle, and check with your dealer.
Passenger Sensing System
The vehicle has a passenger sensing system for the front outboard passenger position.
The passenger airbag status indicator will light on the center display when the
vehicle is started.
Unite ...
If the Off Indicator Is Lit for an Adult-Sized Occupant
If a person of adult size is sitting in the front outboard passenger seat, but
the off indicator is lit, it could be because that person is not sitting properly
in the seat or that the child r ...
Other materials:
Safety Belt Extender
If the vehicle's safety belt will fasten around you, you should use it.
But if a safety belt is not long enough, your dealer will order you an extender.
When you go in to order it, take the heaviest coat you will wear, so the extender
will be long enough for you. To help avoid personal inju ...
Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
Stoplamp/Taillamp
Turn Signal Lamp/Taillamp
Back-up Lamp
To replace a taillamp, turn signal lamp, stoplamp, or back-up bulb:
Open the liftgate. See Liftgate on page 2-8.
Remove the two screws and the lamp assembly.
Turn the bulb socket counterclockwise and remove the so ...
Instrument Panel
Air Vents on page 8-3.
Exterior Lamp Controls on page 6-1.
Horn on page 5-2.
Instrument Cluster on page 5-8.
Windshield Wiper/Washer on page 5-3.
Infotainment on page 7-1.
Information Display.
Hazard Warning Flashers on page 6-3.
Instrument Panel Illumination Control on page 6 ...
