Chevrolet Spark Owners Manual: Interior Glass
To clean, use a terry cloth fabric dampened with water. Wipe droplets left behind with a clean dry cloth.
Commercial glass cleaners may be used, if necessary, after cleaning the interior glass with plain water.
Caution
To prevent scratching, never use abrasive cleaners on automotive glass. Abrasive cleaners or aggressive cleaning may damage the rear window defogger.
Cleaning the windshield with water during the first three to six months of ownership will reduce tendency to fog.
Speaker Covers
Vacuum around a speaker cover gently, so that the speaker will not be damaged. Clean spots with just water and mild soap.
Coated Moldings
Coated moldings should be cleaned.
- When lightly soiled, wipe with a sponge or soft lint-free cloth dampened with water.
- When heavily soiled, use warm soapy water.
Interior Care
To prevent dirt particle abrasions, regularly clean the vehicle's interior.
Immediately remove any soils. Note that newspapers or dark garments that can
transfer color to home furnishings can a ...
Fabric/Carpet/Suede
Start by vacuuming the surface using a soft brush attachment. If a rotating brush
attachment is being used during vacuuming, only use it on the floor carpet. Before
cleaning, gently remove as much ...
Other materials:
Tire Inspection
We recommend that the tires, including the spare tire, if the vehicle has one,
be inspected for signs of wear or damage at least once a month.
Replace the tire if:
The indicators at three or more places around the tire can be seen.
There is cord or fabric showing through the tire's rubb ...
Front Fog Lamp Light
For vehicles with front fog lamps,
this light, in the display on the top of the center stack, comes on when the front
fog lamps are in use.
The light goes out when the front fog lamps are turned off. See Fog Lamps on
page 6-4.
Lamps On Reminder
This light comes on when the exterior
lamps ...
High/Low-Beam Headlamp
Connector Retaining Tab
Connector Release
Headlamp Bulb
To replace a headlamp bulb:
Open the hood. See Hood on page 10-5.
Remove the connector retaining tab (1).
Disconnect the wiring harness connector from the bulb (3) by pressing the
connector release (2) and pulling strai ...
