Chevrolet Spark Owners Manual: Tire Pressure Light
For vehicles with the Tire Pressure
Monitor System (TPMS), this light comes on briefly when the engine is started. It
provides information about tire pressures and the TPMS.
When the Light Is On Steady
This indicates that one or more of the tires are significantly underinflated.
Stop as soon as possible, and inflate the tires to the pressure value shown on the Tire and Loading Information label. See Tire Pressure on page 10-43.
When the Light Flashes First and Then Is On Steady
If the light flashes for about a minute and then stays on, there may be a problem with the TPMS. If the problem is not corrected, the light will come on at every ignition cycle.
See Tire Pressure Monitor Operation on page 10-45.
Engine Coolant Temperature Warning Light
This light comes on briefly while
starting the vehicle.
If it does not, have the vehicle serviced by your dealer. If the system is working
normally the indicator light goes off.
Caution
The eng ...
Engine Oil Pressure Light
Caution
Lack of proper engine oil maintenance can damage the engine. Driving
with the engine oil low can also damage the engine. The repairs would not be covered
by the vehicle warranty.
Check t ...
Other materials:
Interior Glass
To clean, use a terry cloth fabric dampened with water. Wipe droplets left behind
with a clean dry cloth.
Commercial glass cleaners may be used, if necessary, after cleaning the interior
glass with plain water.
Caution
To prevent scratching, never use abrasive cleaners on automotive
glass. ...
Doors
Liftgate
Warning
Exhaust gases can enter the vehicle if it is driven with the liftgate,
hatch/trunk open, or with any objects that pass through the seal between the body
and the hatch/trunk or liftgate. Engine exhaust contains carbon monoxide (CO) which
cannot be seen or smelled. It can caus ...
High/Low-Beam Headlamp
Connector Retaining Tab
Connector Release
Headlamp Bulb
To replace a headlamp bulb:
Open the hood. See Hood on page 10-5.
Remove the connector retaining tab (1).
Disconnect the wiring harness connector from the bulb (3) by pressing the
connector release (2) and pulling strai ...
