Chevrolet Spark Owners Manual: Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
- Stoplamp/Taillamp
- Turn Signal Lamp/Taillamp
- Back-up Lamp
To replace a taillamp, turn signal lamp, stoplamp, or back-up bulb:
- Open the liftgate. See Liftgate on page 2-8.
- Remove the two screws and the lamp assembly.
- Turn the bulb socket counterclockwise and remove the socket.
- Press the bulb in and turn counterclockwise to remove it from the socket.
- Press the new bulb in and turn clockwise to install the bulb into the socket.
- Turn the bulb socket clockwise to reinstall.
- Reinstall the lamp assembly and two screws.
Fog Lamps
To replace the front fog lamp bulb:
Locate the fog lamp under the front fascia.
Disconnect the electrical connector from the fog lamp bulb assembly.
Remove the bulb by turning it counterclockw ...
License Plate Lamp
Attachment Screws
License Plate Bulb
Bulb Socket
To replace a license plate lamp bulb:
Remove the two screws (1) from the license plate lamp assembly.
Turn and pull the license pla ...
Other materials:
Recommended Fluids, Lubricants, and Parts
Recommended Fluids and Lubricants
Fluids and lubricants identified below by name, part number, or specification
can be obtained from your dealer.
Usage
Fluid/Lubricant
Engine Oil
Use only engine oil meeting the dexos1™ specification of the proper
SAE viscosity grade. L ...
Hazard Warning Flashers
The hazard warning flasher button is on the center stack.
(Hazard Warning Flasher): Press
to make the front and rear turn signal lamps flash on and off.
This warns others that you are having trouble. Press the button again to turn
the flashers off.
When the hazard warning flashers are on, ...
Towing the Vehicle
Caution
Incorrectly towing a disabled vehicle may cause damage. The damage
would not be covered by the vehicle warranty.
Have the vehicle towed on a flatbed car carrier or a wheel lift tow truck.
If a wheel lift tow truck is used, the drive wheels cannot contact the road while
the vehicle is ...
