Chevrolet Spark Owners Manual: Safety System Check
Now and then, check that the safety belt reminder light, safety belts, buckles, latch plates, retractors, and anchorages are all working properly.
Look for any other loose or damaged safety belt system parts that might keep a safety belt system from doing its job. See your dealer to have it repaired. Torn or frayed safety belts may not protect you in a crash. They can rip apart under impact forces. If a belt is torn or frayed, get a new one right away.
Make sure the safety belt reminder light is working. See Safety Belt Reminders on page 5-10.
Keep safety belts clean and dry.
See Safety Belt Care on page 3-18.
Safety Belt Extender
If the vehicle's safety belt will fasten around you, you should use it.
But if a safety belt is not long enough, your dealer will order you an extender.
When you go in to order it, take the hea ...
Safety Belt Care
Keep belts clean and dry.
Warning
Do not bleach or dye safety belts.
It may severely weaken them. In a crash, they might not be able to provide adequate
protection.
Clean safety belts only with ...
Other materials:
Antilock Brake System (ABS) Warning Light
This light comes on briefly when
the engine is started.
If the light stays on, turn the ignition to LOCK/OFF or if the light comes on,
stop as soon as possible and turn the ignition off. Then start the engine again
to reset the system.
If the light still stays on, or comes on again while dr ...
Auxiliary Devices
Using the Auxiliary Input Jack
Settings menus and functions may vary depending on vehicle options.
If equipped, the auxiliary input jack in the center stack can be used to connect
external audio devices such as an iPod®, iPhone®, MP3 player, CD player, and other
supported devices for use as an ...
Windshield Wiper/Washer
The windshield wiper/washer lever is on the right side of the steering column.
Move the lever to one of the following positions: HI: Use for fast wipes.
LO: Use for slow wipes.
INT (Intermittent Wipes): Move the lever up to INT for intermittent wipes, then
turn the INT band up for more ...
