Keep belts clean and dry.
Warning
Do not bleach or dye safety belts.
It may severely weaken them. In a crash, they might not be able to provide adequate protection.
Clean safety belts only with mild soap and lukewarm water.
Safety System Check
Replacing Safety Belt System Parts after a CrashFloor Mats
Warning
If a floor mat is the wrong size or is not properly installed,
it can interfere with the pedals.
Interference with the pedals can cause unintended acceleration and/or increased
stopping distance which can cause a crash and injury. Make sure the floor mat does
not interfere with the p ...
High/Low-Beam Headlamp
Connector Retaining Tab
Connector Release
Headlamp Bulb
To replace a headlamp bulb:
Open the hood. See Hood on page 10-5.
Remove the connector retaining tab (1).
Disconnect the wiring harness connector from the bulb (3) by pressing the
connector release (2) and pulling strai ...
Radio Frequency Statement
This vehicle has systems that operate on a radio frequency that complies with
Part 15/Part 18 of the Federal Communications Commission (FCC) rules and with Industry
Canada Standards RSS-GEN/210/220/310, ICES-001.
Operation is subject to the following two conditions:
The device may not cause ...