Chevrolet Spark Owners Manual: Headlamp High/Low-Beam Changer
The headlamps must be on for this feature to work.
Push the turn signal lever away from you to turn the high beams on.
The 
light comes on in the instrument
cluster while the high beams are on and the ignition is turned to ON/RUN.
To return to low beams, push the lever again or pull the lever toward you and release.
Exterior Lamps Off Reminder
A reminder chime will sound when the headlamps or parking lamps are manually
turned on when the ignition is off and a door is open. To disable the chime, turn
the light off. ...
Flash-to-Pass
This feature is used to signal to the vehicle ahead that you want to pass.
Pull the turn signal lever toward you until the high-beam headlamps come on,
then release the lever to turn them off. ...
Other materials:
StabiliTrak® OFF Light
This light comes on briefly while
starting the engine. If it does not, have the vehicle serviced by your dealer.
This light comes on when the StabiliTrak system is turned off.
If StabiliTrak is off, the Traction Control System (TCS) is also off.
If the StabiliTrak and TCS are off, the system do ...
Hood
To open the hood:
Pull the hood release handle inside the vehicle. It is on the lower left
side of the instrument panel.
Go to the front of the vehicle and push the secondary hood release lever
up.
Lift the hood and release the hood prop from the prop retainer,
w ...
Conversions and Add-Ons
Add-On Electrical Equipment
Caution
Some electrical equipment can damage the vehicle or cause components
to not work and would not be covered by the warranty. Always check with your dealer
before adding electrical equipment.
Add-on equipment can drain the vehicle's 12-volt battery, even i ...
