Chevrolet Spark Owners Manual: Fuses and Circuit Breakers
The wiring circuits in the vehicle are protected from short circuits by a combination of fuses, circuit breakers, and fusible thermal links.
This greatly reduces the chance of fires caused by electrical problems.
Look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse. Be sure you replace a bad fuse with a new one of the identical size and rating.
Fuses of the same amperage can be temporarily borrowed from another fuse location, if a fuse goes out. Replace the fuse as soon as you can.
Electrical System Overload
The vehicle has fuses and circuit breakers to protect against an electrical system
overload.
When the current electrical load is too heavy, the circuit breaker opens and
closes, protecting the ci ...
Engine Compartment Fuse Block
The engine compartment fuse block is on the driver side of the vehicle, near
the battery.
Caution
Spilling liquid on any electrical component on the vehicle may
damage it. Always keep the co ...
Other materials:
Automatic Headlamp System
When it is dark enough outside and the exterior lamp control is in the automatic
position, the headlamps come on automatically. See Exterior Lamp Controls on page
6-1.
The vehicle has a light sensor on top of the instrument panel. Make sure it is
not covered, or the headlamps will be on w ...
Safety Locks
The vehicle has rear door safety locks on each rear door that prevent passengers
from opening the rear doors from the inside.
Using the Rear Door Safety Lock
Move the lever up to lock.
Close the door.
Repeat Steps 1 and 2 for the other rear door lock.
Caution
Pulling the inside do ...
Engine Heater
The engine heater can provide easier starting and better fuel economy during
engine warm-up in cold weather conditions at or below -18°C (0°F). Vehicles with
an engine heater should be plugged in at least four hours before starting.
Turn off the engine.
Open the hood and unwrap the ...
