Chevrolet Spark Owners Manual: Fuel Gauge
The fuel gauge indicates about how much fuel is left when the ignition is turned to ON/RUN.
When the tank nears empty, the low fuel warning light will come on.
There is still a little fuel left, but the vehicle's fuel tank should be filled soon. See Low Fuel Warning Light on page 5-20 for more information.
An arrow on the fuel gauge indicates on which side of the vehicle the fuel door is located.
Here are four things that some owners ask about. None of these show a problem with the fuel gauge:
- At the service station, the gas pump shuts off before the gauge reads full.
- It takes a little more or less fuel to fill up than the gauge indicated. For example, the gauge may have indicated the tank was half full, but it actually took a little more or less than half the tank's capacity to fill the tank.
- The indicator moves a little when turning a corner or speeding up.
- The gauge goes back to empty when the ignition is turned off.
Tachometer
The tachometer displays the engine speed in revolutions per minute (rpm).
Caution
If the engine is operated with the rpm’s in the warning area at
the high end of the tachometer, the vehicle could ...
Other materials:
Delayed Locking
This feature delays the locking of the doors until five seconds after all doors
are closed.
When is pressed on the power door
lock switch while the door is open, a chime will sound three times indicating delayed
locking is active.
The doors will lock automatically five seconds after all doo ...
Reclining Seatbacks
Warning
If either seatback is not locked, it could move forward in a sudden
stop or crash. That could cause injury to the person sitting there.
Always push and pull on the seatbacks to be sure they are locked.
To recline the seatback:
Lift the lever.
Move the seatback to the desired p ...
Clock
Radio without Touchscreen
The infotainment system controls are used to access the time and date settings
through the menu system. See Operation on page 7-6 for information about how to
use the menu system.
Setting the Time and Date
Press the or CONFIG
button and select Time and D ...
