Chevrolet Spark Owners Manual: Filling a Portable Fuel Container
Warning
Filling a portable fuel container while it is in the vehicle can cause fuel vapors that can ignite either by static electricity or other means. You or others could be badly burned and the vehicle could be damaged. Always:
- Use approved fuel containers.
- Remove the container from the vehicle, trunk, or pickup bed before filling
- Place the container on the ground.
- Place the nozzle inside the fill opening of the container before dispensing fuel, and keep it in contact with the fill opening until filling is complete.
- Fill the container no more than 95% full to allow for expansion.
- Do not smoke, light matches, or use lighters while pumping fuel.
- Avoid using cell phones or other electronic devices.
Trailer Towing
General Towing Information
The vehicle is neither designed nor intended to tow a trailer.
Filling the Tank
Warning
Fuel vapors and fuel fires burn violently and can cause injury
or death.
To help avoid injuries to you and others, read and follow
all the instructions on the fuel pump island.
Tur ...
Conversions and Add-Ons
Add-On Electrical Equipment
Caution
Some electrical equipment can damage the vehicle or cause components
to not work and would not be covered by the warranty. Always check with your dealer
befor ...
Other materials:
Conversions and Add-Ons
Add-On Electrical Equipment
Caution
Some electrical equipment can damage the vehicle or cause components
to not work and would not be covered by the warranty. Always check with your dealer
before adding electrical equipment.
Add-on equipment can drain the vehicle's 12-volt battery, even i ...
Airbag System Check
The airbag system does not need regularly scheduled maintenance or replacement.
Make sure the airbag readiness light is working. See Airbag Readiness Light on page
5-11.
Caution
If an airbag covering is damaged, opened, or broken, the airbag
may not work properly. Do not open or break the ai ...
High/Low-Beam Headlamp
Connector Retaining Tab
Connector Release
Headlamp Bulb
To replace a headlamp bulb:
Open the hood. See Hood on page 10-5.
Remove the connector retaining tab (1).
Disconnect the wiring harness connector from the bulb (3) by pressing the
connector release (2) and pulling strai ...
