Chevrolet Spark Owners Manual: Engine Oil Change
When the 
%CHANGE DIC message displays,
have the engine oil and filter changed within the next 1 000 km/600 mi. If driven
under the best conditions, the engine oil life system may not indicate the need
for vehicle service for up to a year.
The engine oil and filter must be changed at least once a year and the oil life system must be reset.
Your trained dealer technician can perform this work. If the engine oil life system is reset accidentally, service the vehicle within 5 000 km/ 3,000 mi since the last service.
Reset the oil life system when the oil is changed. See Engine Oil Life System on page 10-10.
Owner Checks and Services
At Each Fuel Stop
Check the engine oil level. See Engine Oil on page 10-8.
Once a Month
Check the tire inflation pressures. See Tire Pressure on page 10-43.
Inspect the tires for wear. Se ...
Tire Rotation and Required Services Every 12 000 km/ 7,500 mi
Rotate the tires, if recommended for the vehicle, and perform the following services.
See Tire Rotation on page 10-48.
Check engine oil level and oil life percentage. If needed, change engine
...
Other materials:
Tire Inspection
We recommend that the tires, including the spare tire, if the vehicle has one,
be inspected for signs of wear or damage at least once a month.
Replace the tire if:
The indicators at three or more places around the tire can be seen.
There is cord or fabric showing through the tire's rubb ...
Conversions and Add-Ons
Add-On Electrical Equipment
Caution
Some electrical equipment can damage the vehicle or cause components
to not work and would not be covered by the warranty. Always check with your dealer
before adding electrical equipment.
Add-on equipment can drain the vehicle's 12-volt battery, even i ...
Front Turn Signal/Parking Lamps
To replace a front turn signal bulb:
Open the hood. See Hood on page 10-5.
Turn the bulb socket counterclockwise and pull it out of the lamp housing.
Pull the bulb straight out of the bulb socket.
Install the new bulb into the socket by pressing it in.
Install the socket into the ...
