Chevrolet Spark Owners Manual: Airbag Readiness Light
This light shows if there is an electrical problem with the airbag system. The system check includes the airbag sensor(s), passenger sensing system, the pretensioners (if equipped), the airbag modules, the wiring, and the crash sensing and diagnostic module. For more information on the airbag system, see Airbag System on page 3-19.
The airbag readiness light comes
on for several seconds when the vehicle is started. If the light does not come on
then, have it fixed immediately.
Warning
If the airbag readiness light stays on after the vehicle is started or comes on while driving, it means the airbag system might not be working properly. The airbags in the vehicle might not inflate in a crash, or they could even inflate without a crash. To help avoid injury, have the vehicle serviced right away.
If there is a problem with the airbag system, a Driver Information Center (DIC) message may also come on.
See Vehicle Messages on page 5-26.
Passenger Safety Belt Reminder Light
There is a passenger safety belt reminder light near the passenger airbag status
indicator. See Passenger Sensing System on page 3-25.
When the vehicle is started, this
light flashes and a chime ...
Passenger Airbag Status Indicator
The vehicle has a passenger sensing system. See Passenger Sensing System on page
3-25 for important safety information. The center display has a passenger airbag
status indicator.
United Stat ...
Other materials:
Windshield Wiper/Washer
The windshield wiper/washer lever is on the right side of the steering column.
Move the lever to one of the following positions: HI: Use for fast wipes.
LO: Use for slow wipes.
INT: Move the lever up to INT for intermittent wipes, then turn the
INT band up for more frequent wipes
or d ...
Traction Control/Electronic Stability Control
The TCS limits wheel spin. The system is on when the vehicle is started.
The StabiliTrak system assists with directional control of the vehicle in difficult
driving conditions. The system is on when the vehicle is started.
To turn off traction control, press and release the TCS/StabiliTrak bu ...
Fabric/Carpet/Suede
Start by vacuuming the surface using a soft brush attachment. If a rotating brush
attachment is being used during vacuuming, only use it on the floor carpet. Before
cleaning, gently remove as much of the soil as possible using one of the following
techniques:
Gently blot liquids with a pap ...
